Talk to an audio consultant

GRADO - BLACK MM CARTRIDGE *PMOUNT*

THIS CARTRIDGE IS A P-MOUNT!!! 

Grado quality analog for a song! The Black features an elliptical diamond and a three-piece OTL cantilever. The Prestige series of cartridges are designed for high output and excellent stability under severe use. A considerable tip mass reduction results in a frequency response to 50 kHz and beyond and tracking forces from 1-2 grams. Acclaimed by experts as virtually the finest pickups in the world at their price. All Grado Prestige styli are user replaceable and normally in stock!

Specifications:
Frequency Response: 10-50
Principal: MI
Channel Separation at 1KHz: 30dB
Input Load: 47K
Output at 1KHz (5CM/sec.): 5mV
Recommended Tracking Force: 1.5Gms
Stylus Type - EllipticalBR>Inductance: 45mH
Resistance: 475Ω
Stylus Replacement: User Replaceable
Mounting: P-Mount
Weight: 5.5

General notes on all Grado Labs phono cartridges:

All Grado cartridges now use a derivation of the moving iron principle which features the following:

OPTIMIZED TRANSMISSION LINE (OTL) STYLUS /CANTILEVER: Grado's OTL provides an ideal transfer of the signal from point to point, e.g., stylus to cantilever to magnet to coils, etc. This has been achieved by eliminating resonance at each of these key junctions. The transmission line cantilever consists of separate sections that are telescoped into each other. All sections are made of different alloys, some sections hollow, other sections solid. These sections are bonded together with materials that act as dampers, and are coated with a black proprietary material which controls and absorbs resonances that travel on the surface of the cantilever (known as skin effects). The OTLstylus/cantilever design will make your records sound quieter, improve the height, width, and depth of the soundstage, and offer more detail than previously obtainable.

PIVOTED FIXED AXIAL CANTILEVER STYLUS-GENERATOR: This design feature is basically quite simple. The 'OTL' cantilever shaft is brought to a fixed axial pivot that supports the entire cantilever assembly. A miniature element attached to the end of the cantilever is allowed to move freely within the lines of flux of a stationary magnetand coil structure.

This system of support is mechanically more accurate (more linear) than conventional 'teeter-totter' designs that utilize an iron armature to balance the mass of the cantilever. The teeter-totter design is supported in the center with a rubber donut mounting. The fixed axial design has a very low tip mass, which results in lower distortion, improved transient response, and longer record life.

This proprietary design allows the implementation of theFLUX-BRIDGER GENERATOR SYSTEM:

The Flux-Bridger design uses four separate magnetic gaps that the miniature element of the cantilever bridges. The miniature element moves between opposing flux gaps creating an increase in flux in one gap while reducing it in the other. The four separate magnetic gaps create a highly efficient and perfectly balanced system. This design requires fewer coil turns than conventional designs.

Fewer coil turns allow Grado cartridges to have lower mass and lower electrical inductance, making them insensitive to tone arm cable capacitance. The four gap design is perfectly balanced and eliminates magnetic residue which contributes to increasing distortion over longer time periods. Grado cartridges reduce distortions that cause listener fatigue.

Each individual cartridge manufactured by Grado is hand assembled and tested for frequency response, channel output, channel balance, phase linearity, inductance and resistance. This meticulous care in design and construction lavished on each Grado cartridge contributes to an unchallenged consistency of performance and guarantee of reliability.