GRAHAM SLEE - REVELATION PHONO PREAMP

The Graham Slee Revelation – This New Switched-Equalization Moving Magnet Phono Stage Preamp is the Most Versatile and is Guaranteed to Breath New Life into Your Record Collection!

The Graham Slee Revelation phono stage preamp is based on our highly successful Era Gold Reflex phono stage preamp. The Era Gold Reflex was positively reviewed by Michael Fremer in September 2007's Stereophile magazine and was awarded recommended system component in the October edition, listed as a "Class A" recommended component along with the much coveted triple dollar value-for-money sign. 100% Music Direct Money Back Guaranteed!

The Revelation phono-stage preamp provides the correct EQ for virtually every phonograph record ever made. It has 7 equalization networks which combine using three 3-way front panel switches to equalize 15 different recording curves - 12 of them equalize known record label recording curves including the modern-day RIAA - 3 are for experimentation. The Revelation is supremely versatile and sounds incredible!

Design Features:
The Revelation uses many similarly selected components from branded specialist high-quality audio component manufacturers as the Jazz Club. These components are selected on real technical merit, and the difference they make, on listening, is obvious.

It differs from the Jazz Club phono stage in its internal grounding method as well as its equalization network impedances. The grounding method has been optimized further to extract even more of the subtle detail, which takes the listening experience another step closer to reality, whatever the music's genre. The EQ network impedances have been lifted to further exploit the ultra-high slew rate of its amplifier stage. These improvements make the Revelation phono stage and the Reflex on which it's based the ultimate in live sounding phono stages.

Like all Graham Slee wideband designs, best performance is obtained by the unit being powered continuously, and a period of "burn-in" (approximately 3 weeks) should be observed for its components to fully form and stabilize. To ensure proper continuous correct operation, the Revelation phono stage is supplied with our IEC approved PSU1 in-line power supply unit. Voltages and cord-sets are country specific and are included with the PSU1.

The cartridge sensitivity and gain is fixed for Moving Magnet or High Output Moving Coil pick-up cartridges and the input impedance is 47k Ohms. For use with low output Moving Coil pick-ups, the Elevator EXP head amplifier should be used ahead of the Revelation. These stages are designed to work together to give an unsurpassed moving coil performance for their price-bands and far beyond.

A mono switch is included on the rear panel to conveniently use a stereo pick-up for mono work. For exacting mono work a mono pick-up should be used in stereo mode and the unused input shorted. It is not advisable to convert stereo recordings to mono using a mono switch as the summing function puts emphasis on centre channel signals.

Specifications
Input sensitivity: 4 mV rms ref 1kHz
Maximum input: 40 mV rms ref 1kHz
Nominal output: 532 mV rms
Maximum output: 5.3 V rms prior to clipping at any frequency
Gain: 42.5 dB (Suitable for Moving Magnets and High Outputs Moving Coils)
Input resistance: 47k Ohms
Input capacitance: 100 pf
Recommended minimum load impedance (output): 10k Ohms
Noise: -68 dB CCIR quasi-peak 20Hz - 20kHz
Distortion: 0.02%
RIAA accuracy: 0.2 dB at each measurement point
RIAA Frequency response: 20Hz - 20kHz
Extended RIAA Frequency Response: 20Hz - 50kHz
Non RIAA Frequency accuracy: Refer to charts
Bandwidth: 1.6MHz limited by input filter
Channel balance: 0.2 dB
Channel separation: 64 dB
Case Size (HWD): 2"x5"x6.5"
Weight: 3Lbs with PSU1 Power Supply