Tributaries Series 8 MKII Power Cable (15 Amp)

Get More Dynamics, Clarity, and Detail with the Hand-Assembled Tributaries Series 8 MKII Power Cable: U.S.A.-Made Design Features Proprietary Winding, Triple Shielding, and 12AWG LC-OFC Wires

Series 8 MKII 3-POLE IEC Power cables begin with extremely high-grade linear crystal copper (LC-OFC) developed specifically for audio applications. Tributaries 8P cables are designed to support low frequency 50/60Hz signals. Current capabilities of power cables are a major concern. Power amps tend to draw current in pulses. Depending on the output of the power amplifier, too small a gauge of the power cable will result in excess resistance that may restrict the peak level of a required pulse limiting the transient response of the amplifier, but if only large conductors are used the cable tends to lose dynamics and also will not respond quickly to transients; the Series 8 power cables are designed with a unique combination of individually insulated large and medium gauge wires to form an overall 12 AWG design supporting current flow and signal dynamics. The Mark II cables are silver-soldered to Tellurium (TE) copper termination pins which mate perfectly with the new Tributaries power connectors allowing the greatest amount of contact area possible for perfect signal transfer. Noise rejection is key factor in the design of an AC power cable. The 8P alternates the twisted lays in each multi-gauge conductor. Alternating lays cancels all levels of magnetic distortion. Triple shielding is employed to prevent outside noise from penetrating the signal. The Mark II power cables will lower the noise floor without restricting audio dynamics leaving you with more of the recorded audio and video for crystal clear dynamic experience.

Series 8 MKII 2-POLE C7 Power cables begin with extremely high-grade linear crystal copper (LC-OFC) developed specifically for audio applications. Tributaries 8P cables are designed to support low frequency 50/60Hz signals. Current capabilities of power cables are a major concern. Power amps tend to draw current in pulses. Depending on the output of the power amplifier, too small a gauge of the power cable will result in excess resistance that may restrict the peak level of a required pulse limiting the transient response of the amplifier, but if only large conductors are used the cable tends to lose dynamics and also will not respond quickly to transients; the Series 8 power cables are designed with a unique combination of individually insulated large and medium gauge wires to form an overall 12 AWG design supporting current flow and signal dynamics. The Mark II cables are silver-soldered to Tellurium (TE) copper termination pins which mate perfectly with the new Tributaries power connectors allowing the greatest amount of contact area possible for perfect signal transfer. Noise rejection is key factor in the design of an AC power cable. The 8P alternates the twisted lays in each multi-gauge conductor. Alternating lays cancels all levels of magnetic distortion. Triple shielding is employed to prevent outside noise from penetrating the signal. The Mark II power cables will lower the noise floor without restricting audio dynamics leaving you with more of the recorded audio and video for crystal clear dynamic experience.

To learn more, just reach out at 312-433-0200.