Rega Neo PSU MK2 Speed Change/Power Supply Unit Provides Advanced Speed Stability: Hear Enhanced Dynamics, Focus, and Imaging from Your LPs
Increase the speed stability and hear better focus, dynamics, pacing, and imaging from your vinyl LPs with the Rega Neo PSU MK2. Designed to mate with the Rega turntables, it is compatible with the following models: P3-24; RP3; Planar 3 (2016-current); RP6; P5; P7; RP40 special edition; RP8; any older Rega turntable fitted with an aftermarket 24v upgrade kit.
Using the same DSP generator found in the Planar 10 power supply, Neo MK2 is built upon a high-stability crystal. The DSP generator divides the accurate signal from the crystal to the exact frequency required to turn the platter at the selected speed, producing a near-perfect sinusoidal waveform to drive the 24v motor. Fine speed adjustments can be made via the rear panel using the supplied custom Neo trim tool.
To check compatibility with your turntable, and see if you need to order the 50Hz or 60Hz version (selectable on the above button menu), please refer to the attached pdf chart or call a Music Direct audio consultant at 312-433-0200.
Output to motor bi-phase: 24 V AC protected by resettable fuse
Power consumption: 7.2 W
Voltage: 24 V AC
Power supply: Rega PS1 only
Speed control step size: 0.01 RPM
PS1: Input 115-120 V ~ 60 Hz / Output 24 V ~ 350 mA AC
Compatibility Guide (PDF, 28 KB)